This webbing is a much better quality
than originally installed on your chair. The original webbing that was installed on your chair or rocker was a tan rubber
type strap. Please make note that the product you will be receiving in just like the product in photo above and
is a much better material.
We need for you to measure your chair and determine the amount of webbing
needed. Please measure the distance from slot to slot, across the frame and front to back to determine how much webbing
is needed. Keep in mind that not all chairs have straps of equal length side to side compared with front to back so please
measure both ways. After you’ve measured both ways multiply the number of straps needed by each length and add
the values for the total lineal footage needed.
When installing it is necessary to cut the individual straps shorter than the actual
opening to make them taunt when installed. We use a 23% stretch factor when doing factory installations.
If you want to allow for the stretch factor when ordering take the total footage and divide that number by 1.23. If
your total footage, to the nearest foot, were seven feet you would divide seven feet by 1.23, which equals 5.69, or rounded,
six feet of webbing needed. You will need two metal clips for each webbing strap so multiply the number of straps by two to
determine how many clips are needed.
We also provide installation instructions that assist with cutting the straps and crimping the ends on each
strap end.
To place order call (812)548-0640 Shipping & Handling is $7.00. You can also send
payment by mail, please write in the memo line the how many feet you need and the amount of clips. Mail payment to William
Tell Antiques 302 9th Street, Tell City, IN 47586. Please make sure to include shipping and handling.
TO ORDER WEBBING PLEASE
CALL 812-548-0640
WED-SAT 11-5 SUN 1-4
BEFORE PLACING ORDER, PLEASE
HAVE YOUR TOTAL LENGTH FIGURED IN FEET.